4. From the drop-down list, select the desired parameter or enter a constant and click "Apply".
The term [...] is replaced by the selected parameter or constant.
5. Repeat step 3 for all operands.
6. Close the dialog with "OK".
7. If you wish to discard your entries, click "Delete". The equation is removed.
Result
The setpoint is calculated by the arithmetic operation.
14.11.7 "Operand 2" (4/5) dialog box
This is where you enter the operand to achieve the desired condition. The following constant
entries are possible depending on the data type of operand 1:
● Floating point value and optional scaling routine (linear, quadratic)
● Enumeration type: Text selection from list
● Unit, also successor/predecessor from basic engineering as option
The value marked in the left window is always taken.
Click on "Next" to go to the "Operator" dialog box.
14.11.8 "Select operand" dialog box
On the left you can select the type of variable for operand 1; on the right the type of variable
for operand 2:
● Parameter from the next highest recipe level
● Process tag: Process value from the automation process
● RPE status: Status of the recipe procedure element
● Constants: Constant value with optional linear or quadratic quantity scaling
● Equation: Arithmetic calculation of setpoints
"Next" button.
After selecting the operand type, the "Next" button brings you to the selection window for the
parameters for this operand type (one each for operand 1 and operand 2) known in SIMATIC
BATCH.
Context help references
14.11 Transition wizard
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 1125
To Next Page
Loading...
Need help?
General
