The display can be set differently for each level of the batch report:
● Status message: Display of the status messages of the equipment phases/operations or
batch control. The list is in ascending chronological order. The time stamp, the event and
the origin are displays with each status message.
● Operating message: Displays the operating texts, the time stamp, the event, the user name
and the comment of the operator per operating message.
● Error message: Displays error and disturbance messages in ascending chronological order.
● Limit value violation: Displays the limit value violations of input materials, output materials
and process parameters.
14.1.9.23 Tab "Batch messages" (settings)
The settings made here apply to the display of measured values when working with the BATCH
data management. Display of the measured values can be activated per level of the batch
report (procedure level, RUP level, ROP level).
On this level, all the configured measured variables with their higher level designations are
listed. Following the listing of the measured variables, the measured variables are displayed
as a trend.
14.1.9.24 "Rename ..." tab
In this dialog, you can enter a new name or/and a new version for an existing batch object
(master recipe, formula etc.).
14.1.9.25 "Candidates" tab
Tree structure
With the tree, you specify the structure view in which the units are displayed for selection in
the "Unit according to condition" field:
● Class view without instances: All unit classes are displayed.
Unit according to condition
All conditions corresponding to the unit candidates are displayed under "Unit according to
condition".
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 815
To Next Page
Loading...
Need help?
General
