● Start: The calculated start time is specified relative to the start of the first unit. If the first
step of a unit recipe is started dependent on a synchronization function, the start value
results from the calculated time of the first unit recipe as far as the synchronization line.
● Run time: Duration calculated from the time values entered in the recipe steps in the format
day:hours:minutes:seconds.
● Condition: If this check box is selected, the conditions for the unit can be edited in this unit
recipe. The third column, "Unit class", is available after this check box is selected.
Description:
You can enter an explanatory description for a selected line here.
Edit:
A dialog opens for the selected line:
● If the "Condition" option was active then two tabs will be displayed. In the first tab,
"Condition", edit the condition for the unit. In the second tab "Allocation" you will see the
preview:
– Left: Under "Device selection" all units that satisfy the specified conditions are displayed
as selected.
– Right: The union set of the phases of all selected units is displayed under "Available
phases".
● If the "Condition" option was not active then only the tab "Allocation" is displayed for unit
selection.
New:
Creates a new reference to unit recipes. Use the "New" function if you want to work with Route
Control or a flat recipe.
Delete:
Deletes the selected row if the corresponding unit recipe was also deleted in the graphic user
interface.
14.1.5 BCC Recipe Properties dialog box
14.1.5.1 "General" tab (Recipe procedure properties)
You have called this properties dialog in the recipe editor for the open master recipe with the
menu item "Header parameters".
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
784 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
Need help?
General
