9.8.4.2 Opening the control recipe
You can see detailed information about the processing of the batch in the control recipe
window. The control recipe of the batch is displayed as it was created in the BATCH Recipe
Editor.
Follow these steps:
1. Select the batch in the batch status list or in the tree.
2. Select the command "Open control recipe" in the shortcut menu for the batch (right-click)
or in the "Control" menu.
Result: The corresponding control recipe is opened and displayed graphically (analogous
to the view in the BATCH Recipe Editor). The toolbar of BatchCC displays buttons for
controlling the processing of the batch. When planned batches are opened, a validation
check is run.
Overview of the control recipe
In BatchCC, you can open the control recipe and also a structural overview of the control
recipe. With more complex control recipes, you can go to the relevant point in the control recipe
window by clicking on a recipe element in the overview.
Select the menu item View > Overview of control recipe.
Result: The overview belonging to the active control recipe window is opened (in the figure
below: bottom left). If no control recipe is open, the overview remains empty (gray).
BATCH Control Center
9.8 Batch control
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 409
To Next Page
Loading...
Need help?
General
