11.5.1.5 ProjectListColumnWidth
String.
Specifies the width of the table columns in the control. This is only possible if you use Gridlist
- 1 for the DisplayMode attribute. The column width setting does not depend on the column
arrangement and is separated by a semicolon.
The default values for the column width are shown in the following table.
Table column Column width
Project 130
Plant;
cannot be used
120
Computer name 120
Redundancy 130
The attribute can be dynamized with the ProjectListColumnWidth name.
11.5.1.6 ProjectListColumnOrderAndVisibility
String.
Specifies the sequence of the table headers in the OS control. This is only possible if you use
the attribute DisplayMode, Gridlist - 1. The values in the following table define the table column.
Table column
title
Value Description
Project 1 Name of the BATCH project
Computer name 3 Name of the BATCH server (master)
Redundancy 4 Name of the BATCH server (standby)
The values are separated by a semicolon and entered in the following syntax: 1;3;4. By
changing the value sequence, you make a corresponding change in the column sequence. By
leaving out a value, the corresponding table column title is not shown in the OS control.
Default: 1;3;4
The attribute can be dynamized with the ProjectListColumnOrderAndVisibility name.
11.5.1.7 ProjectListColumnResizeEnabled
Boolean variable.
Specifies whether or not the column width can be changed during process mode. If yes is set,
an operator can adapt the column width in process mode.
The attribute can be dynamized with the ProjectListColumnResizeEnabled name.
11.5.1.8 ProjectListColumnFilterVisible
Boolean variable.
BATCH OS controls
11.5 Control properties references
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 643
To Next Page
Loading...
Need help?
General
