Description:
In the dialogs for the recipe procedure, the RUP and the ROP sequence, you can enter an
explanatory text.
Additional information
Specifying recipe limits (Page 567)
14.1.3.12 "Transfer parameter" tab
In this dialog, you configure the route control of source locations through an intermediary
location and to a destination location. All configurations you have made on the ES are displayed
in this dialog. To configure route control for SIMATIC BATCH, you must select locations for at
least two parameters (source and destination) in the "Location" column using the "..." button.
It is only practical to define route controls for an equipment phase (transfer phase) that you
have configured in the recipe editor.
Button for showing and hiding table columns
In the tabular view, there is an empty column with a button for hiding or showing the following
columns. This allows you to make the Parameters tab clearer and simpler.
Button for printing parameters
Using a button in the table view, you can open a shortcut menu for printing the displayed
parameters. If you click the Print button in the shortcut menu, the table view along with the
parameters is output immediately to the default printer set in Windows.
If you click Print..., a Windows dialog opens in which you can select another printer set up in
Windows. After making a selection, click "OK" to print the parameters.
Requirements
● Route Control must be installed on the appropriate PCs.
● An equipment property with the data type "Location" is configured in the shared declarations
of the SIMATIC Manager.
● The required location must be assigned to each required Unit (instanced).
List:
● Name: This displays the name assigned at the function block.
● Data type: For steps that are linked to an EOP, EPH or library sequence, the data type is
adopted from the ES or from the library object. The parameter type / transfer types source,
destination or via is displayed.
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 781
To Next Page
Loading...
Need help?
General
