Image 12-7 Recipe with transition query
Batch behavior
Create a new batch with the created master recipe. Release the batch and start it.
During batch processing, the parameter step on the corresponding unit, here R501, sets the
input "UnitStatus" to the value "dirty". If the next transfer function or the alternative branch is
run, depends on the result of the transition. The transfer function is only started when the value
is "clean". The alternative branch is executed in our example. This means that no other phases
are executed and the batch is completed.
Recommended procedure
12.8 How do I configure and use dynamic unit parameters?
SIMATIC BATCH V8.2
694 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
Need help?
General
