Parameters Depending on whether a setpoint or actual value is involved, a parameter
name is selected here from the available parameter names of an AF block.
Setpoint parameters:
● AF6: URP_1 to URP_6
● AF12: URP_1 to URP_12
● AF16S: URP_1 to URP16
● AF24: URP_1 to URP_24
Process value parameters:
● AF6: PV_1_1 to PV_1_6
● AF12: PV_1_1 to PV_1_6 ... PV_2_1 to PV_2_6
● AF16S: PV_1_1 to PV_1_6 ... PV_2_1 to PV_2_6 ... PV_3_1 to PV_3_4
● AF24: PV_1_1 to PV_1_6 ... PV_2_1 to PV_2_6 ... PV_3_1 to PV_3_6 ...
PV_4_1 to PV_4_6
Drop-down list box for pa‐
rameter
In the following drop-down list box you can decide whether ...
● A setpoint parameter without reference to a process value parameter
(none)
● A process value parameter without reference to a setpoint parameter
(none)
● A setpoint parameter with reference to a process value parameter
(PV_x_x )
● A process value parameter with reference to a setpoint parameter
(URP_x)
.
As reference parameter the free parameters, i.e. parameters that are not
yet referenced, and suitable relative to data type and unit, are offered.
"Reference" button This button is displayed when a reference exists from the set value to the
actual value, or vice-versa. click on the button to jump between the refer‐
ence parameters of the set and actual value.
"Archive measured val‐
ue" check box
Activate this check box if you want to establish a connection to a WinCC
archive variable for the instance parameters. This selection is required for
assigning instance parameters to WinCC archive tags. You then make this
assignment on the instance parameters of the corresponding operation
type.
"Test manufacturing in‐
struction" check box
A type parameter is selected here if it is to be provided in the batch log for
the manual check (manufacturing instruction).
"Control strategy parame‐
ter" check box
If this check box is selected, you can make the control strategy settings for
this type at the type parameter.
This option is only available after at least one control strategy type has been
configured under data types.
Parameters
Button
Delete Deletes a phase type parameter.
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 893
To Next Page
Need help?
General
