Siemens SINUMERIK 840D Operation/Programming

2
10.04 Operation
2.10
A
utomatic mode
2
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition 2-127
2.10.7 Overstore
In "Machine Auto" mode you can overstore technological parameters
(auxiliary functions, programmable instructions, etc.) in the working
memory of the NC. You can also enter and execute any NC block.
Overstore does not alter the programs stored in the part program
memory.
Overstore with single
block
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Single Block
 Press the "Single Block" key to execute the program block by
block.
The program automatically stops at the next block boundary.
 Press the "Overstore" softkey.
The "Overstore" window opens.
 Enter the NC blocks to be processed.
Cycle Start
 Press the "Cycle Start" key.
The blocks you have entered are stored. You can observe execution
in the "Overstore" window.
After "Overstore", a subroutine with the content REPOSA, which you
can observe, is executed.
Overstore without single
block
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Cycle Stop
 Press the "Cycle Stop" key.
 Press the "Overstore" softkey.
The "Overstore" window opens.
 Enter the NC blocks to be processed.
Cycle Start
 Press the "Cycle Start" key.

Siemens SINUMERIK 840D Specifications

General

Brand	Siemens
Model	SINUMERIK 840D
Category	Control Unit
Language	English