Siemens SINUMERIK 840D Operation/Programming

8
10.04 Alarms and Messages
8.1 C
y
cle alarms and messa
g
es
8
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition 8-403
62181 "Set rotary axis ... " Prompt to position rotary axis manually.
62182 "Attach inclinable head: ..." Request to load a swivel head.
62183 "Remove inclinable head:..." Prompt to remove inclinable head.
62184 "Replace inclinable head:..." Prompt to replace inclinable head.
62185 "Angle adjusted to angular grid:..." Indication that the desired angle cannot be set
due to the Hirth tooth system. The displayed
angle is set instead.
8.1.3 Messages in the cycles
The cycles output messages in the dialog line of the control. These
messages do not interrupt execution.
They provide information about specific cycle behavior and how
machining is progressing and are usually displayed for the duration of
the machining operation or until the end of the cycle.

Siemens SINUMERIK 840D Specifications

General

Brand	Siemens
Model	SINUMERIK 840D
Category	Control Unit
Language	English