Siemens SINUMERIK 840D Operation/Programming

8
Alarms and Messages 10.04
8.2 Alarms in Sho
p
Mill
8
 Siemens AG, 2004. All rights reserved
8-406 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8.2.3 Description of the alarms
112100
Renumbering error.
Initial state restored.
Explanation You have selected the "Renumber" softkey in the program editor. An
error during renumbering has damaged the program in the memory.
The initial program must now be reloaded to the memory.
Response Alarm display
Program has not been renumbered.
Remedy Create space in the memory, e.g. by deleting an old program. Select
"Renumber" softkey again.
112200
Contour is step in current program sequence. Processing not
enabled
Explanation The selected contour is an element of the program loaded under
"Program".
Response Alarm display
The contour is an element from a loaded program and cannot be
deleted or renamed.
Remedy Remove contour from the loaded program.
112201
Contour is step in current Automatic sequence. Processing not
enabled
Explanation The selected contour is an element of the program loaded under
"Machine Auto".
Response Alarm display
The contour is an element of a program loaded under "Machine Auto"
and cannot be deleted or renamed. After program start, contours
included in the current program cannot be altered under "Program"
while the program is running.
Remedy Stop program run and load program under "Program". Delete contour
from program.

Siemens SINUMERIK 840D Specifications

General

Brand	Siemens
Model	SINUMERIK 840D
Category	Control Unit
Language	English