Siemens SINUMERIK 840D Operation/Programming

3
Programming with ShopMill 10.04
3.10 Miscellaneous functions
3
 Siemens AG, 2004. All rights reserved
3-300 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
3.10.3 Changing program settings
All parameters defined in the program header, with the exception of
the unit of measurement, can be changed at any location in the
program.
The settings in the program header are modal, i.e. they remain active
until they are changed.
Define a new blank, e.g. in the sequential control program, if you want
to change the visible cutout during simulation.
This is useful for the work offset, coordinate transformation, cylinder
peripheral surface transformation and swiveling functions. First
program the functions listed above and then define a new blank.
Settings
>
 Press the "Misc." and "Settings" softkeys.
 Enter the desired parameters.
For a description of the parameters, see Sec. "Creating a new
program".
 Press the "Accept" softkey.
The new settings for the program are loaded.

Siemens SINUMERIK 840D Specifications

General

Brand	Siemens
Model	SINUMERIK 840D
Category	Control Unit
Language	English