Siemens SINUMERIK 840D Operation/Programming

3
Programming with ShopMill 10.04
3.7 Drillin
g
3
 Siemens AG, 2004. All rights reserved
3-260 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
3.7.17 Repeating positions
Function
If you want the tool to re-approach positions that you have already
programmed, the "Repeat positions" function is a quick and easy
solution.
You must specify the number of the position pattern. This is a number
assigned automatically by ShopMill. You will find it inserted after the
block number in the machining plan.
Extract from machining plan, position pattern number=001
Select with softkey
Repeat
positions >
After you have entered the position pattern number, e.g. 1, press the
"Accept" softkey. The position pattern you have selected is then
approached again.
Extract from machining plan; repeat positions in block no. 60

Siemens SINUMERIK 840D Specifications

General

Brand	Siemens
Model	SINUMERIK 840D
Category	Control Unit
Language	English