Siemens SINUMERIK ONE MCP 2400.4c Function Manual

Detailed Description
2.3 Continuous-path mode
Continuous-Path Mode, Exact Stop, LookAhead (B1)
2-10 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Implicit continuous-path mode
If it is not possible to insert approximate positioning blocks due to the very short block path
lengths (e.g., zero-clocked blocks) in continuous-path mode with approximate positioning
G641, the mode is switched over to continuous-path mode G64.
The figure below shows how the function velocity drops according to an overload factor.
W
W
W
%ORFNFKDQJH
%ORFNFKDQJH
<D[LV
;D[LV
3DWKYHORFLW\
9HORFLW\
RI;D[LV
/HDGD[
/HDGI
2YHUO[ D [
/HDGI 2YHUO\ D \
/HDGD \
$[LDOYHORFLW\MXPS
,32
F\FOH
,32
F\FOH
I
2YHUO\ !I 2YHUO[ !
I
2YHUO[ !
9HORFLW\
RI<D[LV
$[LDO
YHORFLW\MXPS
Fig. 2-3 Axial velocity change on block transition

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English