Detailed Description
2.7 Program operation mode
Mode Group, Channel, Program Operation, Reset Response (K1)
2-88 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2.7.8 Part-program start
Start handling
Table 2-4 Typical program sequence
Sequence Command Conditions
(must be satisfied before the
command)
Comments
1 Load program (via the operator
interface or part program)
2 Select AUTOMATIC mode
3 Program preselection Channel preselected
Preselected channel in Re-
set state
User ID sufficient for pro-
gram preselection
4 NC start for preselected channel NC start disable not
set
Reference point approached in
all axes
5 Program execution
6 M02/M30/Reset None End of program
To Next Page
Loading...
Need help?
General
