Detailed Description
2.7 Program operation mode
Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-83
The following actions are executed when the STOP command is triggered:
• Part program execution is stopped at the next block limit (with NC stop at block limit,
M00/M01 or single block), processing is stopped immediately with the other STOP
commands.
• Any auxiliary functions of the current block not yet output by this point are no longer
output.
• The axes of each channel are brought to a standstill along a braking ramp and part
program execution is then stopped.
• The block indicator stops at the point of interruption.
Possible actions in the interrupt state
The following actions can be executed when the part program has been interrupted (program
status stopped, channel interrupted):
• Overstore
References: /BA/, "Operator's Guide"
• Block search
References: /BA/, "Operator's Guide"
• Repositioning to the contour (machine function REPOS)
References: /BA/, "Operator's Guide"
• Oriented tool retraction
References: /PG/, "Programming Guide: Fundamentals"
• Interrupt routine (see Subsection 2.5.12)
• DRF function, workpiece zero offset
References: /FB2/ H1, "Manual and Handwheel Travel"
• Starting an interrupted program with IS
"NC Start" (DB21, ... DBX7.1) or
via NC instruction START from another channel.
2.7.4 RESET command
Command priority
Channel status
The RESET command can be executed in every channel state. This command is aborted by
another command.
To Next Page
Loading...
Need help?
General
