Analyzing waveforms Set up LIN search parameters
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown
above. These controls vary depending on the search Type. Setting the search conditions is similar to
setting the parameters for an Event Trigger
(see page 386).
NOTE. No info
rmation will be displayed in this window until you specify at least one search Type in
the Search Select Control Window (see page 300).
To use
Click the Source box and select the bus number or name from the window. Bus Search Selection
List (see page 98)
Select the type of bus cycle or a ctivity to search for from the Search For drop-down list.
For some Search For selections, you must set additional fields to define other parameters such as for
Data.
In this example, you nee d to set a Data is, Number of Bytes, and Data value (click the Edit
(see page 939)
button). Optionally, you can also set the component thresh old levels through the Logic Thresholds Setup
button.
Click the Search For selections Identifier (see page 351) or Ident & Data (see page 351), Wakeup Frame
(s
ee page
352), Sleep Frame (see page 352),orError (see page 352) to view their parameters.
What do you want to do next?
Learn about bus setups. (see page 95)
350 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
