Chapter 3
KEYPAD FUNCTIONS
(OPERATING WITH THE KEYPAD)
This chapter describes the names and functions of the keypad and inverter operation using the keypad. The
inverter features three operation modes (Running, Programming and Alarm modes) which enable you to run and
stop the motor, monitor running status, set function code data, display running information required for
maintenance, and display alarm data.
Contents
3.1 LED Monitor, Keys and LED Indicators on the Keypad ............................................................3-1
3.2 Overview of Operation Modes................................................................................................... 3-4
3.3 Running Mode...........................................................................................................................3-6
3.3.1 Monitoring the running status.............................................................................................3-6
3.3.2 Monitoring light alarms .......................................................................................................3-8
3.3.3 Setting up frequency and PID commands .........................................................................3-9
3.3.4 Running/stopping the motor.............................................................................................3-14
3.3.5 Jogging operation.............................................................................................................3-14
3.3.6 Remote and local modes .................................................................................................3-15
3.3.7 External run/frequency command....................................................................................3-16
3.4 Programming Mode.................................................................................................................3-17
3.4.1 Setting up basic function codes quickly "Quick Setup".................................................... 3-19
3.4.2 Setting up function codes Menu #1 "Data Setting" .......................................................... 3-22
3.4.3 Checking changed function codes Menu #2 "Data Checking".........................................3-25
3.4.4 Monitoring the running status Menu #3 "Drive Monitoring"..............................................3-26
3.4.5 Checking I/O signal status Menu #4 "I/O Checking"........................................................ 3-30
3.4.6 Reading maintenance information Menu #5 "Maintenance Information".........................3-35
3.4.7 Reading alarm information Menu #6 "Alarm Information"................................................3-40
3.4.8 Copying data Menu #7 "Data Copying"............................................................................ 3-43
3.5 Alarm Mode.............................................................................................................................3-47
3.5.1 Releasing the alarm and switching to Running mode......................................................3-47
3.5.2 Displaying the alarm history............................................................................................. 3-47
3.5.3 Displaying the status of inverter at the time of alarm.......................................................3-47
3.5.4 Switching to Programming mode .....................................................................................3-47
3.6 USB Connectivity ....................................................................................................................3-49
To Next Page
Loading...
Need help?
General
