Quick Start | Conducting a measurement
9
Measuring a blob
A minimum of three measuring points is required to measure a blob. For
measuring point acquisition, you can use the Auto OED measuring tool, for
example. Multiple measuring points are automatically distributed along the entire
contour according to the specified settings.
Select Blob in the geometry palette
Select Auto OED in the tool palette
Cross over the edge of the blob multiple times with the OED
sensor
A new feature is displayed in the feature list
A new measuring point is added each time the edge is
traversed
Distribute the measuring points as evenly as possible
along the contour of the feature.
Tap Finish in the new feature
The blob is displayed in the feature list
The measurement result preview is now displayed
Figure 48: Blob feature in the feature list with Measurement result preview
198
HEIDENHAIN | QUADRA-CHEK 2000 | Operating Instructions | 07/2019
To Next Page
Loading...
Need help?
General
