HEIDENHAIN QUADRA-CHEK 2000 User Manual

Basic operation | Using the Inspector
6
6.14.1 Controls of the Inspector
The Inspector contains the following areas and controls:
Control Function
Quick access menu
The quick access menu displays the current settings for
manual measuring, constructing, and defining:
Unit for linear values (Millimeters or Inch)
Magnification used
Type of measuring point acquisition (automatic or
manual)
Coordinate system used
To adjust the settings of the quick access menu, tap the
quick access menu
Further information: "Adjusting settings in the quick
access menu", Page 87
Position preview
The position preview displays the current axis positions.
If no reference mark search has been performed, the axis
positions are displayed in red.
Further information: "Conducting the reference mark
search", Page 179
To display the position preview in the workspace, tap
the Position preview
The position display is now shown in the workspace
The current content of the workspace is displayed in the
Inspector
Features preview
The features preview displays a reduced view of the
measured, constructed, and defined features.
To display the features view in the workspace, tap the
Features preview
The features view is now shown in the workspace
The current content of the workspace is displayed in the
Inspector
Further information: "Working in the features view",
Page 81
84
HEIDENHAIN | QUADRA-CHEK 2000 | Operating Instructions | 07/2019

HEIDENHAIN QUADRA-CHEK 2000 Specifications

General

Brand	HEIDENHAIN
Model	QUADRA-CHEK 2000
Category	Measuring Instruments
Language	English