EasyManua.ls Logo

HEIDENHAIN QUADRA-CHEK 2000 User Manual

HEIDENHAIN QUADRA-CHEK 2000
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #411 background imageLoading...
Page #411 background image
Specifications | Product dimensions and mating dimensions
19.3.1 Product dimensions with Duo-Pos stand
80
100
132±2
168±1
ISO 7092-4
ISO 7380-M4x8
Md = 2.6 Nm
20°
4.5
5
70
99
150±2
150±1
ISO 7092-4
ISO 7380-M4x8
Md = 2.6 Nm
45°
4.5
5
50
4.5
50
4.5
Figure 97: Product dimensions with Duo-Pos stand
19.3.2 Product dimensions with Multi-Pos stand
15.25
4.5
ISO 14581-M4x8
Md = 2.6 Nm
T25
Md = 15 Nm max.
10°
80°
6.6
10
185±1
18.75
130
170
51
M5
Figure 98: Product dimensions with Multi-Pos stand
19
HEIDENHAIN | QUADRA-CHEK 2000 | Operating Instructions | 07/2019
411

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the HEIDENHAIN QUADRA-CHEK 2000 and is the answer not in the manual?

HEIDENHAIN QUADRA-CHEK 2000 Specifications

General IconGeneral
Resolution0.1 µm
Input Voltage100-240 V AC
DisplayColor touchscreen
Measurement Range200 mm
InterfacesUSB, Ethernet
Power Supply50 to 60 Hz
Weight6 kg

Summary

Safety

General safety precautions

General safety rules and precautions for operating electrical equipment.

Intended use

Defines the product's intended use in commercial and industrial metrology applications.

Personnel qualification

Basic operation

QUADRA-CHEK 2000 – switch-on and switch-off

User login and logout

Commissioning

Steps for commissioning

Detailed breakdown of commissioning steps including basic settings and axis configuration.

Setup

Single steps for setup

Step-by-step guide for basic settings, sensor configuration, and application setup.

Quick Start

Displaying and editing the measurement results

Measuring

Acquiring measuring points

Conducting a measurement

Step-by-step guide for measurements, including object alignment and feature acquisition.

Measurement evaluation

Defining tolerances

Describes available tolerances and how to configure and activate them for features.

Programming

Settings

Sensors

Features

Service and maintenance

Updating the firmware

Procedures for importing new versions of the product's operating system.

What to do if ...

System or power failure

Actions to take in case of system or power failures, including firmware restoration.

Troubleshooting

Guidance on handling faults not covered in the troubleshooting table.

Related product manuals