1-8
dummyheaddummyhead
GENERAL INFORMATION
PGM-FI SPECIFICATIONS
IGNITION SYSTEM SPECIFICATIONS
ELECTRIC STARTER SPECIFICATION
Unit: mm (in)
FUEL SYSTEM SPECIFICATIONS
COOLING SYSTEM SPECIFICATIONS
ITEM SPECIFICATIONS
IAT sensor resistance (at 20°C/68°F) 2.2 – 2.7 k
ECT sensor resistance (at 40°C/104°F) 1.0 – 1.3 k
Injector resistance (at 20°C/68°F) 11 – 13
ITEM SPECIFICATIONS
Spark plug (Iridium) IFR6G-11K (NGK)
Spark plug gap 1.0 – 1.1 mm (0.039 – 0.043 in)
Ignition coil peak voltage 100 V minimum
CKP sensor peak voltage (at 20°C/68°F) 0.7 V minimum
Ignition timing ("F" mark) 12° BTDC at idle
ITEM STANDARD SERVICE LIMIT
Starter motor brush length 12.0 – 13.0 (0.47 – 0.51) 6.5 (0.26)
ITEM SPECIFICATIONS
Throttle body identification number GQ3UA
Idle speed 1,200 ± 100 min
-1
(rpm)
Throttle grip freeplay 2 – 6 mm (1/16 – 1/4 in)
Fuel pressure at idle 343 kPa (3.5 kgf/cm
2
, 50 psi)
Fuel pump flow (at 12 V) 230 cm
3
(7.8 US oz, 8.1 Imp oz) minimum/10 seconds
ITEM SPECIFICATIONS
Coolant capacity Radiator and engine 1.69 liters (1.79 US qt, 1.49 Imp qt)
At draining 1.41 liters (1.49 US qt, 1.24 Imp qt)
Reserve tank 0.13 liter (0.14 US qt, 0.11 Imp qt)
Radiator cap relief pressure 108 – 137 kPa (1.1 – 1.4 kgf/cm
2
, 16 – 20 psi)
Thermostat Begin to open 80 – 84°C (176 – 183°F)
Fully open 95°C (203°F)
Valve lift 8 mm (0.3 in) minimum
Recommended antifreeze High quality ethylene glycol antifreeze containing silicate-free
corrosion inhibitors
Standard coolant concentration 1:1 (mixture with distilled water)
To Next Page
Loading...
Need help?
General
