7-5
dummyheaddummyhead
FUEL SYSTEM
4. To prevent damage and keep foreign matter out,
cover the disconnected connector and pipe end with
the plastic bags [1].
QUICK CONNECT FITTING
INSTALLATION
FUEL PUMP SIDE
Refer to fuel tank installation (page 7-8).
INJECTOR SIDE
• Always replace the retainer and joint rubber of the
quick connect fitting when the fuel feed hose is
disconnected.
• Replace the retainer and joint rubber with the same
manufacturer’s item that was removed.
• Do not bent or twist fuel feed hose.
1. Insert a new retainer [1] into the connector [2].
• Align new retainer locking pawls with the connector
grooves.
2. Set a new joint rubber [1] as shown.
Then press the fuel feed hose into the quick connect
fitting until both retainer pawls [2] lock with a
"CLICK".
• Align retainer tabs with joint rubber grooves.
If it is hard to connect, put a small amount of engine
oil on the injector joint.
To Next Page
Loading...
Need help?
General
