10-15
dummyheaddummyhead
CYLINDER HEAD/VALVES
INSTALLATION
Apply molybdenum oil solution to the camshaft lobes,
journals and thrust surfaces.
Install the camshaft [1].
Align the "1T" mark on the flywheel with the index notch
on the alternator cover (page 3-10).
Align the "1" mark [1] on the cam sprocket with the
upper index line [2] on the cylinder head and install the
cam chain onto the cam sprocket.
Install the cam sprocket onto the camshaft by aligning
the groove with the pin.
Apply engine oil to the cam sprocket bolt threads and
seating surface.
Install the cam sprocket bolt [1].
Hold the flywheel mounting bolt and tighten the cam
sprocket bolt to the specified torque.
Apply the cam chain tension (page 10-12).
Install the rocker arm (page 10-10).
Apply engine oil to a new large O-ring [1] and install it to
the water pump [2].
Install a new O-ring [3] to the water pump.
Install the water pump to the cylinder head.
Align the water pump shaft groove with camshaft tab.
TORQUE:56 N·m (5.7 kgf·m, 41 lbf·ft)
To Next Page
Loading...
Need help?
General
