22-31
dummyheaddummyhead
LIGHTS/METERS/SWITCHES
2. Ground Line Open Circuit Inspection
Check for continuity between the 4P connector [1]
terminal and ground.
Is there continuity?
YES – GO TO STEP 3.
NO – Open circuit in the Green wire
3. Turn Signal/hazard Switch Line Open Circuit
Inspection
Connect the 4P connector [1] terminals with a
jumper wire.
Operate the turn signal switch or push the hazard
switch.
Do the turn signal light illuminate?
YES – GO TO STEP 4.
NO – • Open circuit in the Gray wire
• Faulty turn signal switch or hazard
switch (left handlebar switch)
• Faulty turn signal light circuits
4. Ignition Switch Power Source Line Open Circuit
Inspection
Turn the ignition switch ON.
Measure the voltage between the 4P connector [1]
terminal and ground.
Is there battery voltage?
YES – System is normal, replace the turn signal/
hazard relay.
NO – • Open circuit in the Pink/blue wire
• Blown sub fuse 7.5 A (ILLUMI/STOP/
HORN)
Connection: Green – Ground
Connection: Red/white – Gray
Connection: Pink/blue (+) – Ground (–)
To Next Page
Loading...
Need help?
General
