12-102
dummyheaddummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Apply liquid sealant (Three bond 1207B or equivalent)
to the CKP sensor wire grommet and linear solenoid
valve wire grommet sealing surface.
Set the linear solenoid valve wire grommet [1] and CKP
sensor wire grommet [2] into the groove in the right
crankcase cover.
Apply locking agent to the threads of the right
crankcase cover wire clamp bolts [3] (page 12-4).
Install the wire clamp [4] and tighten bolts.
Install the right crankcase cover (page 12-103).
OIL GUIDE COLLAR REMOVAL/
INSTALLATION
Remove the right crankcase cover (page 12-97).
Remove the snap ring [1] from the right crankcase
cover.
Remove the oil guide collar [1] from the right crankcase
cover with the special tool.
Remove the O-rings from the oil guide collar.
Coat new O-rings [1] with engine oil and install them
into the grooves in the oil guide collar [2].
Install the oil guide collar into the right crankcase cover
until it is seated.
TORQUE:12 N·m (1.2 kgf·m, 9 lbf·ft)
TOOL:
Bearing remover, 20 mm [2] 07931-MA70000
To Next Page
Loading...
Need help?
General
