22-22
dummyheaddummyhead
LIGHTS/METERS/SWITCHES
PARKING BRAKE INDICATOR/SWITCH
(NC700XD/SD)
SYSTEM INSPECTION
If the parking brake indicator [1] does not operate
properly, check the combination meter system
inspection (page 22-9).
If the combination meter system inspection is OK,
check the parking brake switch line as follows:
Turn the ignition switch OFF.
Disconnect the parking brake switch connectors [1].
Connect the connector terminals with a jumper wire.
Turn the ignition switch ON.
The parking brake indicator should come on.
If the indicator does not come on, check for open circuit
in the Black, Brown and Green wires.
If the indicator comes on, check the parking brake
switch (page 22-22).
PARKING BRAKE SWITCH
INSPECTION
Disconnect the parking brake switch connectors.
Check for continuity between the parking brake switch
terminals [1].
There should be continuity with the parking brake lever
pulled, and no continuity with the lever released.
If the parking brake switch does not operate properly,
replace the switch (page 22-23).
To Next Page
Loading...
Need help?
General
