22-12
dummyheaddummyhead
LIGHTS/METERS/SWITCHES
MIL AND ENGINE OIL PRESSURE INDICATOR ARE
STAY ON, TACHOMETER, HIGH COOLANT
TEMPERATURE INDICATOR AND HISS INDICATOR
DOES NOT COME ON AND SHIFT INDICATOR "–"
(NC700XD/SD) IS BLINKING (when the ignition
switch turned ON)
• Check the following items before starting the
inspection:
– Check for loose or poor contact on the
combination meter 16P (Gray) connector and
ECM/PCM 33P connector, then recheck the DTC.
– Inspect the sub fuse 7.5 A (ENG STOP)
• If the ECM/PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (NC700XD/
SD) (page 12-120)
1. Combination Meter Serial Line Short Circuit
Inspection
Turn the ignition switch OFF.
Remove the windscreen (page 2-23).
Remove the dust cover [1] and disconnect the
combination meter 16P (Gray) connector [2].
Remove the following:
– Shroud/side cover (NC700X/XA) (page 2-14)
– Side cowl (NC700S/SA) (page 2-13)
– Center cross plate (NC700XD/SD) (page 2-32)
Disconnect the following:
– ECM 33P (Black) connector (NC700X/XA/S/SA)
[1]
– PCM 33P (Gray) connector (NC700XD/SD) [2]
[2] [2]NC700X/XA/XD: NC700S/SA/SD:
[1][1]
[1]
NC700X/XA/S/SA:
NC700XD/SD:
[2]
To Next Page
Loading...
Need help?
General
