Honda NC700 2012 User Manual

18-11
dummyheaddummyhead
REAR WHEEL/SUSPENSION
Apply grease to a new O-ring [1].
Install the damper rubbers [2] and the O-ring into the
left wheel hub.
Install the driven flange assembly [1] into the left wheel
hub.
Tighten the driven sprocket nuts [2] to the specified
torque in a crisscross pattern in 2 or 3 steps.
Apply grease to a new dust seal lips.
Install the dust seal [3] to the driven flange.
Install the pulser ring (NC700XA/XD/SA/SD) [1] onto
right wheel hub.
Install the rear brake disc [2] with its arrow mark [3]
facing out.
Install and tighten new brake disc bolts [4] to the
specified torque in a crisscross pattern in 2 or 3 steps.
Apply grease to a new dust seal lips.
Install the dust seal [5] to the right wheel hub.
Do not get grease on the brake disc.
INSTALLATION
Install the right side collar [1] and left side collar [2].
[2][1]
TORQUE:108 N·m (11.0 kgf·m, 80 lbf·ft)
[3]
[1] [2]
TORQUE:42 N·m (4.3 kgf·m, 31 lbf·ft)
NC700XA/XD/SA/SD shown:
[3]
[4]
[2] [5][1]
[2] [1]

Honda NC700 2012 Specifications

General

Brand	Honda
Model	NC700 2012
Category	Motorcycle
Language	English