14-9
dummyheaddummyhead
CRANKCASE/TRANSMISSION/BALANCER
Remove the right mainshaft bearing [1] from the upper
crankcase.
Remove the mainshaft assembly [1].
Disassemble the mainshaft assembly.
Clean all disassembled parts in solvent thoroughly.
• Keep track of the disassembled parts (gears,
bushings, washers, and snap rings) by sliding them
onto a tool or a piece of wire.
• Do not expand the snap ring more than necessary
for removal. To remove a snap ring, expand the
snap ring and pull it off using the gear behind it.
SHIFT DRUM/SHIFT FORK
Remove the shift drum bearing set plate bolts [1] and
set plate [2].
Remove the fork shaft [1] and shift forks [2].
To Next Page
Loading...
Need help?
General
