3-22
dummyheaddummyhead
MAINTENANCE
Remove the rear brake reservoir mounting bolt [1] and
reservoir [2].
Remove the cover screws [3], reservoir cover [4], set
plate [5] and diaphragm [6].
Temporarily install the reservoir and mounting bolt to
the reservoir stay lower hole [7] using a 6 mm nut [8].
Align the reservoir tab [9] with the reservoir stay cut out
[10].
Fill the reservoir with DOT 4 brake fluid from a sealed
container to the "UPPER" level line [11].
Remove the 6 mm nut, mounting bolt and reservoir.
Install the diaphragm, set plate and reservoir cover.
Install and tighten the cover screws to the specified
torque.
Install the reservoir and rear brake reservoir mounting
bolt.
Align the reservoir tab with the reservoir stay upper hole
[12].
Tighten the rear brake reservoir mounting bolt to the
specified torque.
BRAKE PADS WEAR
FRONT BRAKE PADS
Check the brake pads for wear.
Replace the brake pads if either pad is worn to the
bottom of wear limit grooves [1].
For brake pad replacement.
– NC700X/S (page 19-16)
– NC700XA/XD/SA/SD (page 19-17)
REAR BRAKE PADS
Check the brake pads for wear.
Replace the brake pads if either pad is worn to the
bottom of wear limit grooves [1].
For brake pad replacement (page 19-18).
TORQUE:1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
TORQUE:10 N·m (1.0 kgf·m, 7 lbf·ft)
[8] [3]
[1][9][2][1][2]
[10]
[7]
[6]
[5]
[4]
[11]
[12]
Always replace the
brake pads as a set
to assure even disc
pressure.
Always replace the
brake pads as a set
to assure even disc
pressure.
NC700X/S: NC700XA/XD/SA/SD:
[1] [1]
To Next Page
Loading...
Need help?
General
