19-35
dummyheaddummyhead
HYDRAULIC BRAKE
ASSEMBLY
Install a new dust seal [1] into the seal groove in the
caliper.
Apply 0.4 g (0.01 oz) minimum of silicone grease to the
outer surface of the brake shaft [1].
Position the brake shaft so that the punch mark [2] is
between the index lines [3] (installation range), and
screw the shaft into the caliper.
Make sure that the punch mark is positioned between
the index lines with the shaft fully installed.
PAD SPRING
BRACKET PIN BOOT
BRAKE SHAFT
BRAKE ARM
LOCK NUT
17 N·m (1.7 kgf·m, 13 lbf·ft)
CALIPER PIN BOLT
22 N·m (2.2 kgf·m, 16 lbf·ft)
CALIPER PIN BOOT
SLEEVE
CALIPER PIN BOOT
BRACKET
BRAKE SHAFT BOOT
ADJUSTER BOLT/PISTON
DUST SEAL
PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
BRAKE PADS
CALIPER BODY
Installation
range
[2]
[3]
[3]
[1]
To Next Page
Loading...
Need help?
General
