HP 1910 User Manual

240
Item Descri
p
tion
DOT1 TLV
Setting
Port VLAN ID Select to include the PVID TLV in transmitted LLDPDUs.
Protocol VLAN ID
Select to include port and protocol VLAN ID TLVs in transmitted
LLDPDUs and specify the VLAN IDs to be advertised.
If no VLAN is specified, the lowest protocol VLAN ID is transmitted.
VLAN Name
Select to include VLAN name TLVs in transmitted LLDPDUs and specify
the VLAN IDs to be advertised.
If no VLAN is specified, the lowest VLAN carried on the port is
advertised.
DOT3 TLV
Setting
Link Aggregation Select to include the link aggregation TLV in transmitted LLDPDUs.
MAC/PHY
Configuration/Status
Select to include the MAC/PHY configuration/status TLV in transmitted
LLDPDUs.
Maximum Frame Size Select to include the maximum frame size TLV in transmitted LLDPDUs.
Power via MDI
Select to include the power via MDI TLV and power stateful control TLV
in transmitted LLDPDUs.
MED TLV
Setting
LLDP-MED Capabilities
Select to include the LLDP-MED capabilities TLV in transmitted LLDPDUs.
Inventory
Select to include the hardware revision TLV, firmware revision TLV,
software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV and asset ID TLV in transmitted LLDPDUs.
Network Policy Select to include the network policy TLV in transmitted LLDPDUs.
Extended
Power-via-MDI
Capability
Select to include the extended power-via-MDI TLV in transmitted
LLDPDUs.
Emergency Number
Select to encode the emergency call number in the location
identification TLV in transmitted LLDPDUs and set the emergency call
number.
Address
Select Address to encode the civic address information of the network
connectivity device in the location identification TLV in transmitted
LLDPDUs. In addition, set the device type, which can be a DHCP server,
switch or LLDP-MED endpoint, country code, and network device
address.
When you configure the network device address, select the address
information type from the list, type the address information in the field
below and click Add next to the field to add the information to the
address information list below. To remove an address information
entry, select the entry from the list, and click Delete. The civic address
information can include language, province/state, country, city, street,
house number, name, postal/zip code, room number, post office box,
and if necessary, additional information.
Network Device
Address
Setting LLDP parameters for ports in batch
1. Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.
2. Select one or multiple ports on the port list.

HP 1910 Specifications

General

Brand	HP
Model	1910
Category	Switch
Language	English