HP 1910 User Manual

68
TIP:
• You can click Reset to clear all system logs saved in the log buffer on the Web interface.
• You can click Refresh to manually refresh the page, or you can set the refresh interval on the Lo
g
Setup
page to enable the system to automatically refresh the page periodically. For more information, see
"Setting buffer capacity and refresh interval."
2. View system logs.
Table 11 Field description
Field Descri
p
tion
Time/Date Displays the time/date when system logs are generated.
Source Displays the module that generates system logs.
Level
Displays the system information levels. The information is classified into eight levels
by severity:
• Emergency—The system is unavailable.
• Alert—Action must be taken immediately.
• Critical—Critical conditions.
• Error—Error conditions.
• Warning—Warning conditions.
• Notification—Normal but significant condition.
• Information—Informational messages.
• Debug—Debug-level messages.
Digest Displays the brief description of system logs.
Description Displays the contents of system logs.
Setting the log host
You can set the loghost on the Web interface to enable the system to output syslogs to the log host. You
can specify at most four different log hosts.
To set the log host:
1. Select Device > Syslog from the navigation tree.
2. Click the Loghost tab.
The loghost configuration page appears.

HP 1910 Specifications

General

Brand	HP
Model	1910
Category	Switch
Language	English