HP 1910 User Manual

486
Item Descri
p
tion
Action
Select the action to be performed for packets matching the rule.
• Permit—Allows matched packets to pass.
• Deny—Drops matched packets.
MAC
Address
Filter
Source MAC Address
Select the Source MAC Address box and enter a source MAC
address and a mask.
Source Mask
Destination MAC
Address
Select the Destination MAC Address box and enter a destination
MAC address and a mask.
Destination Mask
COS(802.1p priority) Specify the 802.1p priority for the rule.
Type Filter
LSAP Type
Select the LSAP Type box and specify the DSAP and SSAP fields in
the LLC encapsulation by configuring the following items:
• LSAP Type—Frame encapsulation format.
• LSAP Mask—LSAP mask.
LSAP Mask
Protocol Type
Select the Protocol Type box and specify the link layer protocol type
by configuring the following items:
• Protocol Type—Frame type. It corresponds to the type-code field
of Ethernet_II and Ethernet_SNAP frames.
• Protocol Mask—Protocol mask.
Protocol Mask
Time Range Select the time range during which the rule takes effect.
Adding an IPv6 ACL
1. Select QoS > ACL IPv6 from the navigation tree.
2. Click the Create tab.
The IPv6 ACL configuration page appears.
Figure 467 Adding an IPv6 ACL
3. Add an IPv6 ACL.
4. Click Apply.

HP 1910 Specifications

General

Brand	HP
Model	1910
Category	Switch
Language	English