2H0/2HZ
1-3-15
U020
Initializing all data
Description
Initializes all the backup RAM on the main PWB to return to the original settings.
Refer to *1 of the maintenance mode item list about the item initialized.
Also, initializes the settings with the system menu in order to restore default settings simultaneously.
Reregister the fax settings since the settings are initialized when the fax kit is installed.
Purpose
To be executed as required.
Caution
Run the maintenance item U411 (Adjusting the scanner automatically) after initialization (see page 1-3-68).
Method
1. Press the start key.
2. Select the destination.
3. Press the start key. All data in the backup RAM is initialized.
4. Turn the main power switch off and on.
An error code is displayed in case of an intialization error.
When ERROR 09 occurred, turn main power switch off then on, format the hard disk using maintenance
item U024, and execute initialization using maintenance item U020. For other errors occurred, turn main
power switch off then on, and execute initialization using maintenance item U020.
Error codes
Maintenance
item No.
Description
Display Description
INCH Inch (North America) specifications
EUROPE METRIC Metric (Europe) specifications
ASIA PACIFIC Metric (Asia Pacific) specifications
Codes Description
ERROR 01 Configuration initialization error
ERROR 02 Counter initialization error
ERROR 03 One-touch initialization error
ERROR 04 Panel program initialization error
ERROR 05 Event log initialization error
ERROR 06 Account initialization error
ERROR 07 Address book initialization error
ERROR 08 Department initialization error
ERROR 09 Document box initialization error
ERROR 0a Permissibility initialization error
ERROR 0b Job log initialization error
ERROR 20 Engine initialization error
ERROR 40 Scanner initialization error
To Next Page
Loading...
Need help?
General
