Introduction
This manual covers the items required for installing, connecting and setting up the MITSUBISHI CNC.
Supported models are as follows:
Abbreviations in this manual are as follows:
Read this manual thoroughly and understand the product's functions and performance before starting to use.
This manual is written on the assumption that all optional functions are added, but the actually delivered device may
not have all functions.
The unit names, cable names and various specifications are subject to change without notice. Please confirm these
before placing an order.
Be sure to keep this manual always at hand.
This manual notes a reference chapter as "Chapter: Section: Paragraph".
(Example) For "4.1.1 Environment Conditions inside the Control Panel" :
"General Specifications: Environment Conditions: Environment Conditions inside the Operation"
("4.1.1 Environment Conditions inside the Operation" included in "4.1 Environment Conditions" of "4 General
Specifications")
Notes on Reading This Manual
(1) This book is configured as follows.
Refer to the following chapters as necessary.
Installation and connection: Chapter 1 to 15
Setup: Chapter 16 to 33
(2) This manual explains general parameters as viewed from the NC.
For information about each machine tool, refer to manuals issued from the machine tool builder.
If the descriptions relating to "restrictions" and "allowable conditions" conflict between this manual and the
machine tool builder's instruction manual, the later has priority over the former.
(3) This manual is intended to contain as much descriptions as possible even about special operations.
The operations to which no reference is made in this manual should be considered "impossible".
(4) This manual is for the machine tool builders who set up the NC system.
(5) Do not connect to the pin described as "NC" on the pin assignment table of the connector.
Supported models Abbreviations in this manual
M800S Series M850S, M830S
M80 Series M80 TypeA, M80 TypeB
E80 Series E80 TypeA, E80 TypeB
Abbreviations Supported models
M800, M800 Series M800S Series
M80, M80 Series M80 Series
M800/M80, M800/M80 Series M800S Series/M80 Series
M8, M8 Series M800S Series/M80 Series/E80 Series
To Next Page
Loading...
Need help?
General
