M800S/M80/E80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER
417
IB-1501269-J
18.4 Install APLC C Language Module
Carry out the procedures of this section to register APLC C language module. When you do not use APLC C language
module, there is no need to carry out the procedure.
(1) Push the [APLC Data] menu.
-> The screen is changed to APLC C language module installation screen.
(2) Push the [Install] menu.
(3) When a confirmation screen appears, push the [Yes] menu.
(Note) Do not power OFF during installation.
(4) When installation is finished, "Installation completed" appears.
(Note 1) To uninstall the APLC data, push the [Install] menu instead of [Uninst] in the step (2).
(Note 2) The maximum size of APLC C language module (aplc.o) for installation is 120KB. If the size exceeds 120KB,
installation will fail and the massage "The file "aplc.o" is size over." will appear.
(Note 3) Installation or uninstallation is not executed when the [Yes] menu is pressed continuously after the previous
installation or uninstallation operation. Push Return key to return to the initial screen and start the
procedure again.
,QVWDOOLQJ
To Next Page
Loading...
Need help?
General
