M800S/M80/E80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER
416
IB-1501269-J
18.3 Install Start-up Screen
Carry out the procedures of this section to register custom start-up screen. When you use standard start-up screen,
there is no need to carry out the procedures.
(1) Push the [Custom Startup] menu.
-> The screen is changed to the start-up screen installation screen.
(2) Push the [Install] menu.
(3) When a confirmation screen appears, push the [Yes] menu.
(Note) Do not power OFF during installation.
(4) When installation is finished, "Installation completed" appears.
(Note 1) To uninstall the start-up screen data, push the [Uninst] menu instead of [Install] in the step (2).
(Note 2) Installation or uninstallation is not executed when the [Yes] menu is pressed continuously after the previous
installation or uninstallation operation. Push Return key to return to the initial screen and start the
procedure again.
,QVWDOOLQJ
To Next Page
Loading...
Need help?
General
