M800S/M80/E80 Series Connection and Setup Manual
17 Setting the Hardware
387
IB-1501269-J
17.4 Setting Up without Connecting to the Motor/Drive Units at the Startup
of Drive Unit
When connecting the motor or drive unit after setting up the system, set the axis data beforehand to enable the operation
without the motor or drive unit. The following shows the procedures.
Setting Up without Connecting to the Motor
The axis detachment can be used for servo axis. The detach function cannot be used for spindle.
(1) Set the drive unit rotary switch and "#1021 mcp_no" for the axis that is not connected to the motor.
(2) Set the parameter "#1070 axoff" to "1" for the axis that is not connected to the motor.
(3) Do (a) or (b).
(a) Set parameter "#8201 AX. RELEASE" to "1" for the axis that is not connected to the motor.
(b) Turn ON the control axis detach signal (Y780) for the axis that is not connected to the motor.
Setting Up without Connecting to the Drive Unit
Set the following parameters.
(1) Set "#1021 mcp_no" (for the servo axis) or "#3031 smcp_no" (for the spindle axis) to the axis that is not connected
to the drive unit.
(2) Set the following parameters to the axis that is not connected to the drive unit.
For the servo axis: Set "#2018 no_srv" to "1".
For the spindle axis: Set "#3024 sout" to "0".
After connecting to the drive unit, make sure to set "#2018 no_srv" to "0" and "#3024 sout" to "1".
To Next Page
Loading...
Need help?
General
