M800S/M80/E80 Series Connection and Setup Manual
35 Appx.2: Protection Setting
568
IB-1501269-J
Operating the maintenance screen reduces a phenomenon in which defective workpieces run out due to an operation
mistake, by implementing a restriction with seven operation levels. The operation level varies depending on the MTB
specifications. Refer to the instruction manual issued by the MTB for details.
35.1 Protect Setting Screen
Display items
Display items Details
(1) Current opn. level Displays the current operation level.
(2) Passwords at operation
levels 4 to 6
Displays the passwords at operation levels 4 to 6 with "****".
(3) Protection level of each
data item
Displays the protection level of each data item.
The data set below the current operation level can be changed as needed.
Changing the protection level displays the message "Pro lev change" at the upper right.
Change: Specify the protection level to change data (including a case to input a file).
Output: Specify the protection level to output a file.
Menus
Menus Details
Changes the present authenticated password to the non-authenticated state and switches the operation level to 0 to
3. Which of the operation level between 0 and 3 being switched is followed by the PLC signal of the protection level.
Changes the operation levels.
Changes the password of the operation levels 4 to 6.
Changes the protection level of each data item.
Saves the protection level setting of each data item.
(1)
(2)
(3)
To Next Page
Loading...
Need help?
General
