Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
20 Sequence Program Writing
431
IB-1501269-J
20.5 Setting the Parameters on GX Developer
(Note) There are two methods of ladder programming; independent program method and multi-program method,
which makes differences in parameter settings. An incorrect parameter setting in the ladder programming may
cause a write error.
For details of the parameter settings, refer to the "PLC Development Manual".
20.5.1 Parameter Setting Screen
(1) Displaying the project data list and parameter setting screen
Display the "Project data list" window with the following operations. Double-click on "PLC parameter" to open the
parameter setting screen. The same operation can be carried out by designating the data type "Parameter" and the
data name "PLC parameter" from the tool bar.
[View] -> [Project data list] and then double-click "PLC parameter".
(2) Displaying the parameter setting screen
Perform the following operations to display the parameter setting screen. The characters of tab in "red" show that
the settings are the initial values.

Project data list window
Too l b ar
PLC parameter


Mitsubishi M80 series Specifications

General

Brand	Mitsubishi
Model	M80 series
Category	Control Unit
Language	English