Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
15 Cable
367
IB-1501269-J
15.3.7 DG30 Cable
Max. cable length: 10m
Application: Battery cable
(drive unit - battery box, drive unit - drive unit)
15.3.8 G380 Cable
Max. cable length: 30m
Application: Optical communication cable
for wiring between drive units (outside panel)
for optical communication repeater unit
Use when the cable length is 10m or more to 30m or less.
(Note 1) Binding the cables too tight with tie-wraps could result in an increased loss or a disconnection. Use a
cushioning material such as a sponge or rubber when bundling the cables and fix so that the cables do not
move. Recommended clamp material: CKN-13SP KITAGAWA INDUSTRIES.
(Note 2) Never bundle the cables with vinyl tape. The plasticizing material in the vinyl tape could cause the PCF cable
reinforced sheath to damage.
(Note 3) Loop the excessive cable with twice or more than the minimum bending radius.
[OPT]
Connector: CF-2D101-S
Recommended manufacturer:
Japan Aviation Electronics
Wire material:
Hard clad type PCF optic cable
Recommended manufacturer:
Oki Electric Cable
Cable Minimum bending radius: R
2-core cable (section with reinforced sheath) 50mm
2-core cable (section without reinforced sheath) 25mm

1
2
1
2
BT
LG
BT
LG
0.2mm
2
Drive unit side connector
Connector: PAP-02V-O
Contact: SPHD-001G-P0.5
Drive unit side connector
Connector: PHR-2-BL
Contact: SPH-0022GW-P0.5S
(J.S.T)
(J.S.T)
OPT OPT
Section with reinforced sheath
Section without reinforced sheath
OPT
1
2
OPT
1
2

Mitsubishi M80 series Specifications

General

Brand	Mitsubishi
Model	M80 series
Category	Control Unit
Language	English