M800S/M80/E80 Series Connection and Setup Manual
19 Setting the Parameters and Date/Time
422
IB-1501269-J
19.3 Setting the Parameters for the Machine Specifications
(1) On the Mainte screen, select [Mainte] and then [Psswd input]. Enter the machine parameter password in the setting
area and press the [INPUT] key.
(Note 1) To enter the character "A", press the shift key and then "A" key. Do not press both keys at the same time.
(2) Go back to the Mainte screen.Then select [Param].
Set the parameters according to the machine specifications. Setting of the following parameters is necessary.
Base system parameters
"#1025 I_plane (Initial plane selection)"
"#1026 base_I (Base axis I)"
"#1027 base_J (Base axis J)"
"#1028 base_K (Base axis K)"
"#1029 aux_I (Flat axis I)"
"#1030 aux_J (Flat axisJ)"
"#1031 aux_K (Flat axis K)"
Base axis specification parameters
"#1603 PLCdev_no (Axis device assignment No.)"
(Note) Set this in one of the following cases:
- When the system has five ore more part systems
- When the number of axes in the part system is nine or more
- When you want to change the assignment of axis device
[Device]
(Note) The device Nos corresponding to (1) to (32) differ depending on device type.
$1 $2 $3 $4
(1) (9) (17) (25) Axis 1
(2) (10) (18) (26) Axis 2
(3) (11) (19) (27) Axis 3
(4) (12) (20) (28) Axis 4
(5) (13) (21) (29) Axis 5
(6) (14) (22) (30) Axis 6
(7) (15) (23) (31) Axis 7
(8) (16) (24) (32) Axis 8
To Next Page
Loading...
Need help?
General
