M800S/M80/E80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER
415
IB-1501269-J
18.2 Install Custom Screen
Carry out the procedures of this section to register custom screens. When you use standard screens only, there is no
need to carry out the procedure.
(1) Push the [Custom Data] menu.
-> The screen is changed to the custom data installation screen.
(2) Push the [Install] menu.
(3) When a confirmation message appears, push the [Yes] menu.
(Note) Do not power OFF during installation.
(4) When installation is finished, "Installation completed" appears.
(Note 1) To uninstall custom screen data, push the [Uninst] menu instead of [Install] in the step (2). Note, however, that
both "Custom screen" and "PLC alarm message" are uninstalled by the uninstallation operation.
(Note 2) The size of custom data must be 12MB or less. If it exceeds 12MB, the following message appears and the
installation fails.
"Installation Error. Please check the file size."
(Note 3) Installation or uninstallation is not executed when the [Yes] menu is pressed continuously after the previous
installation or uninstallation operation. Push Return key to return to the initial screen and start the
procedure again.
,QVWDOOLQJ
To Next Page
Loading...
Need help?
General
