M800S/M80/E80 Series Connection and Setup Manual
22 Setting the Position Detection System
456
IB-1501269-J
There are two kinds of position detection system: one is "relative position detection", which establishes the reference
position (zero point) at every CNC power-ON; the other is "absolute position detection", which allows to start the
operation without establishing the reference position (zero point) again after the CNC power-ON.
22.1 Adjusting the Absolute Position Detection System
There are four types of the absolute position zero point initialization set: "marked point alignment method", "marked point
alignment method II", "machine end stopper method", and "dog-type".
Set the parameter "#2049 type (Absolute position detection method)" for the type and method of absolute position zero
point initialization set.
The required components differ depending on the detection method.
Each method has the following characteristics
(1)Marked point alignment method I
Align the table side’s mark and the machine side’s mark.
The first grid point which is returned from the marks are aligned is determined as the basic position.
Because the first grid point which is returned from the marks are aligned is determined as the basic position, the
reproducibility is kept even the position information is lost due to runnning out of battery etc.
(2) Marked point alignment method II
Align the table side’s mark and the machine side’s mark.
The position where the marks are aligned is determined as the basic position.
Because the position where the marks are alinged is determined as the basic position, the reproductivity is low if the
position information is lost due to running out of battery etc.
(3) Machine end stopper method
[When #2059 zerbas = 0]
Push the table against the machine end stopper.
The position where the table is pushed against the machine end stopper is determined as the basic position.
[When #2059 zerbas = 1]
Push the table against the machine end stopper.
The first grid point which is returned from where the table is pushed against the machine end stopper is
determined as the basic position.
There are two types of the machine end stopper method: automatic initialization and manual initialization.
When the automatic initialization is applied, the axis travels automatically after the JOG is started.
When the manual initialization is applied, the axis travels by handle mode or JOG mode while confirming each
operation.
(4) Dog method
This method requires a dog sensor.
Move the table until the dog is kicked, and the first grid point after the dog OFF is determined as the basic position.
The parameters for the approach speed and grid mask amount etc. need to be adjusted.
Marked point
alignment method I
Marked point
alignment method II
Machine end stopper method Dog type
Required
component
None None Machine end stopper Dog, dog-sensor
#2049 type 24 1 3
Basic position
The first grid point
which is returned from
where the mark is
aligned.
The position where the
marks are aligned.
The position where the table is pushed
against the machine end stopper.
Or the first grid pointed which is
returned from where the table is pushed
against the machine end stopper.
The first grid point after
the dog OFF.
Reference
22.1.1 Basic Position
Alignment Method I
22.1.2 Basic Position
Alignment Method II
22.1.3 Machine End Stopper Method:
Automatic Initialization
22.1.4 Machine End Stopper Method: Manual
Initialization
22.1.5 Dog-type
To Next Page
Loading...
Need help?
General
