Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
24 Setting the Machine Error Compensation
498
IB-1501269-J
24.1.3 Setting Method
24.1.3.1 Using a Linear Axis as Basic Axis
(1) When "mdvno" or "pdvno" exists at both ends of "rdvno"
The compensation beyond the setting range ("mdvno" to "pdvno") will be based on the compensation amount at
"mdvno" or "pdvno".
(2) When the range compensated is only the positive range
When the machine position is beyond "pdvno", the compensation will be based on the compensation amount at
"pdvno". If the machine position is on the negative side in this case, no compensation will be executed.
Division point number #4101 #4102 #4103 #4104 #4105 #4106 rdvno 4103
Specified machine position -300.000 -200.000 -100.000 100.000 200.000 300.000 mdvno 4101
Real machine position -299.999 -200.000 -100.003 100.002 200.002 299.999 pdvno 4106
Compensation
amount
Incremental
amount method
2 6 -6 -4 0 6 spcdv 100.000
Absolute
amount method
-2 0 6 -4 -4 2
Division point number #4113 #4114 #4115 #4116 #4117 rdvno 4112
Compensation
amount
Incremental
amount method
-42062 mdvno4113
Absolute
amount method
-4 -2 -2 4 6 pdvno 4117
#4101 #4103#4102 #4104 #4105 #4106
2
1
-1
-2
-3
(1) (3) ( - 3) ( - 2) (0) (3)
(3)
(-2)
(0) ( - 2)
(-1) (1)
3
Compensation
amount
in incremental
amount method
Error
Basic axis machine
coordinate
Compensation
amount
in absolute
amount method
#4114#4113 #4116 #4117
2
1
-1
-2
-3
( - 2) (1) (0) (3) (1)
(-2)
(-1)
(2)
3
#4115
(-1)
(3)

Compensation
amount
in incremental
amount method
Basic axis machine
coordinate
Compensation
amount
in absolute
amount method
Error

Mitsubishi M80 series Specifications

General

Brand	Mitsubishi
Model	M80 series
Category	Control Unit
Language	English