M800S/M80/E80 Series Connection and Setup Manual
24 Setting the Machine Error Compensation
499
IB-1501269-J
(3) When the range compensated is only the negative range
When the machine position is beyond "mdvno", the compensation will be based on the compensation amount at
"mdvno".
(4) When compensation is executed in a range that contains no reference position
In this case, the compensation is executed in the range from "mdvno" to "pdvno".
This setting is also applied to the compensation executed in an range in which a machine position is negative and a
reference position is not included.
Division point number #4125 #4126 #4127 #4128 #4129 #4130 rdvno 4130
Compensation
amount
Incremental
amount method
-22620-6mdvno4125
Absolute
amount method
-2 -4 -2 4 6 6 pdvno 4130
Division point number #4135 #4136 #4137 #4138 #4139 #4140 rdvno 4134
Compensation
amount
Incremental
amount method
-2 -2 6 2 mdvno 4136
Absolute
amount method
-2 -4 2 4 pdvno 4140
#4128#4127 #4130#4126
2
1
-1
-2
-3
(3) (1) (0) (-3)
(3)
(3)
(-1)
3
#4129
(2)
(-2)
(-1) (1)
#4125
(-1)
Compensation
amount
in incremental
amount method
Error
Basic axis
machine
coordinate
Compensation
amount
in absolute
amount method
#4136#4135 #4138 #4139
2
1
-1
-2
-3
(1)
(-1) (-1) (3)
(-1)
(-2)
(2)
3
#4137
(1)
#4140
Error
Compensation
amount in
incremental amount
method
Basic axis machine
coordinate
Compensation
amount in
absolute amount
method
To Next Page
Loading...
Need help?
General
