Polycom CX5500 Unified Conference Station Administrator’s Guide 1.1.0
Polycom, Inc. 138
Next, in the reg-advanced.cfg template, enter the dedicated address in thirdPartyName for all phones
of the BLA group and set the line type to shared. In this example, two or more phones can use the same
dedicated address 6044533036 as the BLA address, and the line type has been set to shared from the
default private.
For example, two phones 6044533036 and 6044533037 are configured with the 3036 BLA address.
There is an incoming call to 6044533036 from 3038 that causes 3036 and 3037 phones to show the
incoming call.
Enable Voicemail Integration
The phone is compatible with voicemail servers. You can configure each phone or line registration per
phone to subscribe with a SIP URL to a voicemail server contact. You can also configure the phone to
access voicemail with a single soft key, for example, the Messages icon in the status bar on the CX5500
system. When you access the voicemail server, the phone gives a visual and audio alert; you can also
configure a message waiting alert to indicate that you have unread voicemail messages. The table
Voicemail Integration shows you the parameters you can configure.
Voicemail Integration
Central Provisioning Server
To turn one-touch Voicemail on or off
sip-interop.cfg > up.oneTouchVoiceMail
Specify the URI of the message center server
sip-interop.cfg > msg.mwi.x.subscribe
Set the mode of message retrieval
sip-basic.cfg > msg.mwi.x.callBackMode
Specify a contact number for the phone to call to retrieve messages,
callBackMode must be set to Contact
sip-interop.cfg > msg.mwi.x.callBack
Specify if message waiting notifications should display or not
Specify if the the phone screen backlight illuminates when you
receive a new voicemail message
site.cfg > mwi.backLight.disable
To Next Page
Loading...
Need help?
General
