Polycom CX5500 Unified Conference Station Administrator’s Guide 1.1.0
Polycom, Inc. 306
<dot1x><eapollogoff/>
The table 802.1X EAP over LAN (EAPOL) Logoff Parameters lists configurable parameters.
802.1X EAP over LAN (EAPOL) Logoff Parameters
sec.dot1x.eapollogoff.enabled
1
If 0, the phone will not send an EAPOL Logoff message on behalf of the disconnected supplicant. If 1, the feature
is enabled and the phone will send an EAPOL Logoff message on behalf of the disconnected supplicant
connected to the phone’s secondary (PC) port.
sec.dot1x.eapollogoff.lanlinkreset
1
If 0, the phone software will not reset (recycle) the LAN port link in the application initiation stage. If 1, the LAN
port link will be reset in the application initiation stage.
1
Change causes phone to restart or reboot.
<hostmovedetect/>
The table Host Movement Detection Parameters lists configurable parameters.
Host Movement Detection Parameters
sec.hostmovedetect.cdp.enabled
1
If set to 1, the phone software will unconditionally send a CDP packet (to the authenticator switch port) to indicate
a host has been connected or disconnected to its secondary (PC) port.
sec.hostmovedetect.cdp.sleepTime
1
If sec.hostmovedetect.cdp.enabled is set to 1, then there will be an x microsecond time interval between
two consecutive link–up state change reports. This will reduce the frequency of dispatching CDP packets.
1
Change causes phone to restart or reboot.
<TLS/>
The table TLS Parameters lists configurable TLS parameters. For the list of configurable ciphers, see
Configurable TLS Cipher Suites.
This parameter also includes <profile/>and <profileSelection/>.
To Next Page
Loading...
Need help?
General
